Re: gEDA-user: Design Flow Roadmap starting point

[Steve Meier <smeier@xxxxxxxxxxxxxxxxxxx>]

One practical solution for very small parts is to hid the refdes on the
board but make a large assembly drawing that has them.

Steve Meier

DJ Delorie wrote:
>> S2/S2/L1  S2/S2/C1 and S2/S2/U1
>>
>> is the RenumberBlock funtion capable of this?
>>     
>
> It currently pulls the last string of digits (suffix) off for
> renumbering, but pulling the first string shouldn't be too hard.  It
> doesn't give you automatic updating, though.  If you edit the master
> block, you'd cut out the copies, and re-copy/renumber the master block
> to make new copies.
>
> We could script this if we had an action to select a region, but it
> would certainly be better if it "just knew" about such blocks.
>
>   
>> Because when you use those virtual 01005 capcitors there isn't a lot
>> of room for a readable refdes as it is
>>     
>
> Too true.  I didn't even bother with a silkscreen on the furnace
> board, and that's only 0603s.
>
>
> _______________________________________________
> geda-user mailing list
> geda-user@xxxxxxxxxxxxxx
> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
>
>   



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user