Re: gEDA-user: gsch2pcb (gnetlist) generates corrupted pcb output

[Stefan Salewski <mail@xxxxxxxxxxxx>]

On Fri, 2010-06-11 at 02:56 +0200, Stefan Salewski wrote:
> On Fri, 2010-06-11 at 02:49 +0200, Stefan Salewski wrote:
> 
> > Oh -- when I open your schematic with gschem I have some missing symbols
> > (red triangles) -- 
> > 
> 
> Sorry, that was the wrong scope.sch (the larger one from your homepage).
> I will try the other now.
> 

All fine with more than 600 capacitors here, (debug-options (list 'stack
200000)) not necessary.

Output of gsch2pcb is fine, and I can open the board with PCB, no
serious error message in log window, and I can disperse the capacitors.

PCB log:

Looking for default_font in .
Can't open ./default_font for reading
Looking for default_font in /usr/bin/../share/pcb
Found default_font in /usr/bin/../share/pcb
File 'board.pcb' has no font information, using default font
Looking for default_font in .
Can't open ./default_font for reading
Looking for default_font in /usr/bin/../share/pcb
Found default_font in /usr/bin/../share/pcb
Note:  home directory is "/home/stefan"
The gtk gui currently ignores "grey50"as part of a menuitem resource.
Feel free to provide patches


stefan@AMD64X2 ~/mmm $ gsch2pcb project  
=====================================================
gsch2pcb backend configuration:

   ----------------------------------------
   Variables which may be changed in gafrc:
   ----------------------------------------
   gsch2pcb:pcb-m4-command:    /usr/bin/m4
   gsch2pcb:pcb-m4-dir:        /usr/share/pcb/m4
   gsch2pcb:pcb-m4-confdir:    /etc/pcb
   gsch2pcb:pcb-m4-path:       /usr/share/pcb/m4  /etc/pcb  $HOME/.pcb  .
   gsch2pcb:m4-command-line:   /usr/bin/m4 -d  -I/usr/share/pcb/m4 -I/etc/pcb -I$HOME/.pcb -I. /usr/share/pcb/m4/common.m4 - >> board.pcb

   ---------------------------------------------------
   Variables which may be changed in the project file:
   ---------------------------------------------------
   gsch2pcb:use-m4:            yes

=====================================================
Using the m4 processor for pcb footprints

----------------------------------
Done processing.  Work performed:
0 file elements and 656 m4 elements added to board.pcb.

Next step:
1.  Run pcb on your file board.pcb.
    You will find all your footprints in a bundle ready for you to place
    or disperse with "Select -> Disperse all elements" in PCB.

2.  From within PCB, select "File -> Load netlist file" and select 
    board.net to load the netlist.

3.  From within PCB, enter

           :ExecuteFile(board.cmd)

    to propagate the pin names of all footprints to the layout.





_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user