Re: gEDA-user: Comments on pcb's g-code exporter & HeeksCAD/HeeksCNC FOSS program for pcb milling

[Markus Hitter <mah@xxxxxxxxxxx>]

Am 15.11.2010 um 06:55 schrieb dfro@xxxxxxxxx:

> I tried to draw an outline in an 'outline' layer and 'pcb' just  
> turned the trace lines into an isolation routing outline.

Ouch. This shouldn't happen. Did you apply all 24 patches? If yes,  
could you send me (not to the list) the .pcb file showing this  
behaviour ?

> I must not be getting your explanation. Do I use a rectangle in the  
> 'outline' layer to define the outline?

Exactly. A rectangle, or any number of lines drawing another area.  
Milled is always a rectangle, though.


Markus

- - - - - - - - - - - - - - - - - - -
Dipl. Ing. (FH) Markus Hitter
http://www.jump-ing.de/







_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user