[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: gEDA-user: no pins in JUMPER10

El miÃ, 08-11-2006 a las 08:14 -0500, John Luciani escribiÃ:
[snip]
> Below are the refdes conventions that I use (that I have
> seen on *many* schematics).
> 
> I may have missed a few since this is BC (before Cappuccino).
> 
> (* jcl *)
> 
> Substitute an integer value for <n>
> 
> value  component type
> -------- -------------------------
> R<n> Resistor
> L<n> Inductor
> C<n> Capacitor
> 
> B<n> Battery
> J<n> Connector
> P<n> Connector (usually plugs that mate with J<n>)
> K<n> Relay
> S<n> Switch
> T<n> Transformer
> 
> D<n> Diode
> Q<n> Transistor
> U<n> IC
> X<n> Crystal

Added to the wiki:
http://geda.seul.org/wiki/geda:master_attributes_list#refdes

Thanks,

Carlos



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user