Re: gEDA-user: no pins in JUMPER10

["John Luciani" <jluciani@xxxxxxxxx>]

On 11/9/06, Carlos Nieves Ónega <cnieves.mail@xxxxxxxxx> wrote:
> El mié, 08-11-2006 a las 08:14 -0500, John Luciani escribió:
> [snip]
> > Below are the refdes conventions that I use (that I have
> > seen on *many* schematics).
> >
> > I may have missed a few since this is BC (before Cappuccino).
> >
> > (* jcl *)
> >
> > Substitute an integer value for <n>
> >
> > value  component type
> > -------- -------------------------
> > R<n> Resistor
> > L<n> Inductor
> > C<n> Capacitor
> >
> > B<n> Battery
> > J<n> Connector
> > P<n> Connector (usually plugs that mate with J<n>)
> > K<n> Relay
> > S<n> Switch
> > T<n> Transformer
> >
> > D<n> Diode
> > Q<n> Transistor
> > U<n> IC
> > X<n> Crystal
>
> Added to the wiki:
> http://geda.seul.org/wiki/geda:master_attributes_list#refdes
>
> Thanks,
>
> Carlos

Carlos,

 Thanks for adding these.

(* jcl *)

--
http://www.luciani.org


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user