Re: gEDA-user: pcb, how to remove mm garbage (very short lines)?

[Stefan Salewski <mail@xxxxxxxxxxxx>]

Am Mittwoch, den 19.11.2008, 15:44 +0200 schrieb Duncan Drennan:

> 
> I drew a bunch of random lines (grid = 0.1mm) and then deleted them
> one at a time. On one corner a small trace was left over. Below are
> the .pcb line elements. You can see that the first Line is just
> 1/100th of a mil long in the Y direction, and this is the line which
> was left over. I am guessing this is what Stefan is sometimes seeing.
> 

Thanks for verifying -- I think this is what I was talking about.

Best regards

Stefan Salewski




_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user