Re: gEDA-user: pcb, how to remove mm garbage (very short lines)?

["Duncan Drennan" <duncan.drennan@xxxxxxxxx>]

> The only way to "fix" this is to change to something other than
> 1/100mil internal coordinates.

Maybe more important is to figure out whether this needs to be fixed.
The effect that results is an irritation rather than board breaking.
If it did result in a short the netlister would detect that.
Unconnected copper is not normally a major problem (but looks messy).

Is unconnected copper detected by the DRC? Is there a way to delete an
entire line instead of just a segment?


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user