Re: gEDA-user: next PCB release - 1.99za vs 4.0

[Peter Clifton <pcjc2@xxxxxxxxx>]

On Fri, 2010-09-10 at 18:11 -0400, DJ Delorie wrote:
> 
> If you use the line tool to cut up a polygon, how do you edit that cut
> later? 

If the cut was in fact an anti-line, just a clearance created, then it
would remain editable - although I'm not sure quite how you'd render it.

-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)
Tel: +44 (0)1223 748328 - (Shared lab phone, ask for me)



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user