Re: gEDA-user: PCB + GL latest (patch for indirect rendering support)

[Peter Clifton <pcjc2@xxxxxxxxx>]

On Wed, 2009-02-11 at 21:12 +0000, gdedwards@xxxxxxxxxxxxxxxx wrote:
> Hi Peter,
> 
> I've been running the branch this evening and already tripped over a
> rendering issue of moderate severity - one of the polygons on my board is
> not being filled.
> 
> Here's the screenshot of the HEAD build:
> 
> http://www.muppetlabs.pwp.blueyonder.co.uk/geda/board_HEAD.png
> 
> Note the extension of the ground fill under the two big caps top left,
> then look at the render from the branch:
> 
> http://www.muppetlabs.pwp.blueyonder.co.uk/geda/board_pcjc2.png
> 
> That poly is not filled.

Were you viewing on the backside?

I just completed a board design since I added the contour culling, and
discovered that I've got it wrong for the flipped coordinate systems
other than a head-on view of the board.

Will fix that when I get chance.

> The board file is at
> 
> http://www.muppetlabs.pwp.blueyonder.co.uk/geda/loop_conditioner_board.pcb.gz

Thanks!

-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user