Re: gEDA-user: I need to open and print a PCB created in ExpressPCB:What are my options?

["Jeremy Pedersen" <ubernerd.jeremy@xxxxxxxxx>]

So it's possible to hand solder or reflow these things at home? Better yet, can you do double sided SMT boards? I always thought you coudn't do it because you would have to have components touching the surface of the reflow skillet on one side while the other side was supposed to reflow. Also, am I right to suppose that since you use gEDA that there are footprints in gEDA for SMD components?

That's something I hadn't thought of. I do have a school e-mail address, so I will check out On-semi.

I couldn't really tell you if this is a particularly weird MOSFET. We just started semiconductor devices at school, so I'm really only familiar with Diodes so far. Here's the part at both Digi-Key and Mouser:

Mouser ) 511-STN1NF10
Digi-Key ) IRLD110-ND

I think they're the same: I'm not really sure. MilesTag specs the Digi-key part.

Thanks all,
Jeremy

_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user