Re: gEDA-user: pcb doesn't find my pins

[Peter Clifton <pcjc2@xxxxxxxxx>]

On Wed, 2010-03-03 at 16:42 -0500, Jim wrote:
> > Perhaps the pin identifier U102-J1-1 is causing issues.
> >
> >   
> Thanks everyone.  I think I understand the issues.  I'll just go with 
> pin numbers 1-40 and drop the J1 and J2 mess.  It won't match the part, 
> but I can translate easy enough.  There are only 6 connections, VCC, GND 
> MOSI MISO SS and SCLK.  Most of the rest of the pins either go to ground 
> or VCC,

That was just a guess.. you might try "J1_1" as the pin number, for
example, which will still closely match the part, but not (assuming this
is the issue) confuse the net-list code.

-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user