Re: gEDA-user: pcb DRC

[timecop <timecop@xxxxxxxxx>]

> I believe there are some fab's who run a DRC check with a web interface
> as you upload the design files. I doubt this will be available until
> you've committed to fabrication though.

freedfm from 4pcb is free but it sucks and they will spam you.
anyway, if you're at the point where you need to rely on web-based DRC
for gerbers (thus you don't trust the tools you use) its time to move
on

>
> --
> Peter Clifton
>
> Electrical Engineering Division,
> Engineering Department,
> University of Cambridge,
> 9, JJ Thomson Avenue,
> Cambridge
> CB3 0FA
>
> Tel: +44 (0)7729 980173 - (No signal in the lab!)
> Tel: +44 (0)1223 748328 - (Shared lab phone, ask for me)
>
>
>
> _______________________________________________
> geda-user mailing list
> geda-user@xxxxxxxxxxxxxx
> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
>


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user