[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: gEDA-user: Symbol question - suggestions?

On Fri, Jan 07, 2011 at 12:06:12PM +0100, Johnny Rosenberg wrote:
> So, if I decide to use a 74-power symbol after all, is there any way I can  
> design it making it automatically understand where it belongs, so I don't  
> need to manually enter all those âU1, U2, U3â und so weiter?
	You need to manualy assign number to that particular component.

	Either you can autonumber everything and than manualy renumber
	the 74-power (probably leaving holes in the numbering) or number
	the 74 and 74-power when you place it with the same number
	manualy and use autonumbering without the 'override' feature.
> If I wanted a lot of work, I could draw my components with a pen on a  
> piece of paper and then scan the whole thingâ

	Martin Kupec

geda-user mailing list